Learning how to use the bore snake would be the best backup cleaning solution for your regular deep cleaning kit. You can carry the bore snake or fold-up bore snake in diverse calibres with you when practicing at shooting range or hunting at the field. Your firearm is likely to perform at its peak when it is properly cleaned, and maintained. It is extremely important that you clean the firearm regularly after every use. You can either deep clean the firearm using cleaning rod or use bore snake for quick cleaning of the firearm. Below is the step by step guide to clean the firearm using bore snake.
Step One
Before you hunting it is important that you confirm that the gun is clean properly without any dust or debris in the chamber and no magazine. If you are about the clean the gun start by removing the magazine and then double check if anything is present in the chamber.
Step Two
Use the best gun cleaning solvent for your gun and spray the solvent across the gun, especially on the bronze bristle of the bore snake. Many gun owners prefer to saturate the spray and allow it to set for minutes before starting the cleaning process. But, it is important that your focus on cleaning the gun right away after spraying the solvent.
Step Three
Take one end of the bore snake that has the brass weight and pour it down to the barrel chamber and guide it thoroughly until the bronze part of the bore snake comes in contact with the cleaning solvent.
Step Four
Once it comes in contact with the solvent and the brush section of bore snake gets wet with the solvent, it is the time to start giving a resistance.
Step Five
Now you have to hold the bore snake and pull it with little force as necessary. If you have the bore snake in the small size calibre of the barrel then you need to put lots of pressure to get it through for deep cleaning.
Step Six
The primary floss area located behind the bronze bristle comes out easily and it helps in removing the carbon build-up that is scraped off from the solvent and the brush of the bore snake.
Step Seven
As you pull back the bore snake and all carbon build-up is removed successfully, you are done with the cleaning process. Now you need to take a look at the barrel and reassemble the highly polished mirror. If you see any debris accumulated, then go back to step one and start it over again.
It is important that you do the step 7 process twice or thrice to ensure that the cleaning is done properly and no debris is left behind in the barrel after cleaning. Some people use oil at the end of the bore snake and this helps in leaving light coat of oil on the barrel once it is done with leaning. To learn more about gun cleaning with bore snake visit the website https://cleangunguide.com/best-bore-snakes-reviews/ that shares cleaning guide for firearms using bore snake.
